Previously Featured Builds

build

Karnovim Salim

Karnovim Salim

Hello everybody in PASSDIY... Here, I attached the picture of my ZEN amplifier, and in fact, they are brothers... The… More...
build

Mario Rada

Mario Rada

This is just a brief description of my pass projects recently finished. Two monoblocks A1.2, each built in a cabinet… More...

Zen Variations 7 — Nelson Pass / 2004

One of the performance issues raised by the original Son of Zen (Audio Electronics, #2, 1997) was its efficiency figure, which was charitably described as 4% (500 watts in, 20 watts out). You may recall that this was dictated by the original requirements - no feedback, no capacitors in the signal path, and a single gain stage. Zen Variation 6 relaxed the requirements on feedback and capacitors in order to provide a tutorial exercise about “super-symmetric” feedback. The performance was improved in distortion and output impedance, but the efficiency was only slightly improved, largely because we used most of the… More...

Zen Amplifier Revisited — Nelson Pass / 1994

I must say that I have been very gratified by the response to the Zen amplifier from the last issue of TM. Since writing the article I have had an opportunity?to build another 25 copies of the amplifier, listen to it on a larger variety of loudspeakers, absorb criticism from the readership, and generally meditate on the project. Areas of criticism of the design all relate to the objective, measurable performance, but in addressing them, I found that the subjective performance improved with the measurements. All of the changes are performed without altering the original topology of the project amplifier.… More...

Copyright © 2016 Pass Laboratories, Inc. All rights reserved

Telephone: 530.878.5350